Horsepower™ Installation Guide
July 2016
10
Horsepower
™
Sapper™ Horsepower Mount for 20lb. Monitor
STEPS
CONNECT THE MAST TO THE
HORSEPOWER ASSEMBLY:
1. Insert four M6 spring nuts (I) into the
bottom beam of the pre-assembled
Horsepower assembly with the spring tabs
facing upward (two nuts per channel.)
2. Align the spring nuts (I) with the holes in the
base mounting bracket (H) and attach the
base mounting bracket (H) using (4) M6-1
x 14mm flat head machine screws (G).
3. Install top mounting bracket bushing
(J) by aligning snap tabs and mating
slots. Press and snap into place.
4. Insert two M6 spring nuts (I) into the top
beam of the Horsepower assembly with
the spring tabs facing downward.
5. Align the spring nuts (I) with the holes in the
top mounting bracket (K) and attach the top
mounting bracket (K) to the spring nuts (I) with
(4) M6-1 x 25mm flat head machine screws (L).
Be sure the brackets are vertically
aligned before tightening the screws.
6. Insert the mast (A) through the hole in the top
mounting bracket (K) and press firmly onto the
curved ribs of the base mounting bracket (H).
7. Attach the mast (A) to the base
mounting bracket with a ½-13 x 1.5"
Flat Head Socket Screw (F).
CONNECT THE MONITOR MOUNT TO THE MAST:
8. Remove monitor base and hardware,
from the monitor. Retain all hardware.
9. Remove the mast cap (B) and the stop
screw (E) from the top of the mast (A).
10. Rotate the height adjustment knob (C) to
the desired height. (Note: The Knoll logo on
the adjustment knob should be face up.)
11. Slide the sleeve mount (M) onto and
down the mast (A) until it rests securely
on the height adjustment knob (C).
12. Reinstall the mast cap (B) and
the stop screw (E).
13. Place movement joint (O) against back
of monitor or television, with Knoll logo
toward top of monitor and attach the VESA
plate using appropriate customer supplied
hardware. VESA plate can accommodate
75 mm or 100 mm hole patterns.
: Movement joint can hold up to 20lbs.
:
Check VESA compliancy and hole
pattern on monitor or television as Knoll
monitor solutions are designed to work with
VESA compliant monitors only. The Knoll
VESA plate can accommodate 75mm or
100mm hole patterns. Knoll movement joints
do not ship with screws and are designed
to accept an M4 or M5 screw; length is
dependent on the specific monitor or
television and screw should be tested prior to
installation to ensure correct length; Knoll is
not responsible for use of incorrect screws.
14. Attach monitor plate (with movement joint) to
sleeve arm (M) by inserting fast release pin (N).
15.
To activate the anti-theft
feature, back the set screw at the
bottom of the fast release pin partially
out with a
1
/
16
" Allen wrench.
