KMT Streamline SL-IV, Руководство по эксплуатации и обслуживанию

Страница: 55 / 132

SECTION 7
HIGH PRESSURE WATER
Nov 2002 p. 7-3 05126826
7.2.1 HP & LP Water Piping
Disconnect from/Reconnect to Waterjet Pump
WARNING
Before performing maintenance on the waterjet pump
observe electrical LOCK OUT/TAG OUT procedures.
1. With 13/16” open wrench loosen and remove HP Piping attached to
discharge HP check valve. Move tubing to clear work area.
2. For servicing discharge HP check valve on the intensifier assembly,
refer to section 7.3.1.”Discharge HP Check Valve”.
3. The sealing head can be removed with the discharge HP check valve
attached. Remove the low pressure water quick disconnect and
gently pry the collar off the sealing head.
4. With the HP piping and the low pressure cutting water plumbing
disconnected, the following operations can be performed:
•
Sealing head can be removed from the HP cylinder
•
HP cylinder can be removed from hydraulic cylinder head
•
HP seals (sealing head and plunger) can be serviced
After the pump has been reassembled, then the HP water piping,
quick disconnect and collar are reinstalled as follows:
5. Slide inlet water collar over sealing head until it rests against the
head nut. Connect LP inlet water quick disconnect to collar.
6. Install the HP water piping. Tighten HP connections using a 13/16”
crowfoot wrench. Use a 30mm (1-3/16”) wrench for back-up on the
sealing head, and a 1” wrench for back-up on the elbow. Turn on
cutting water supply and check for low pressure leaks.
CAUTION
Check that all proximity switches are properly installed
and secured prior to starting the motor. Failure to
tighten proximity switch hold down screws (2 each per
proximity switch) will result in hydraulic oil spraying in
general directions.
7. Start the waterjet pump. Operate at low pressure (without a cutting
orifice) to flush the HP passages, then operate at high pressure with
orifice installed to check for leaks.