8 — English
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.
Only the parts shown on the parts list are intended to be
repaired or replaced by the customer. All other parts should
be replaced at an Authorized Service Center.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
WARNING:
Upon removal, cover the battery pack’s terminals with
heavy-duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its compo-
nents. Batteries must be recycled or disposed of properly.
Also, never touch both terminals with metal objects and/
or body parts as short circuit may result. Keep away from
children. Failure to comply with these warnings could
result in fire and/or serious injury.
OPERATION
MAINTENANCE
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes resulting in possible
serious injury.
WARNING:
To avoid serious personal injury, always remove the
battery pack from the product when cleaning or
performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 9
AFTER SPANISH LANGUAGE SECTION.
USING THE IMPACT DRIVER
See Figures 5 - 6, page 9.
WARNING:
Do not drive a screw where there is likely to be hidden
wiring behind the surface. Contact with a “live” wire will
make exposed metal parts of the tool “live” and shock
the operator. If you must drive a screw where hidden wire
may be present, always hold tool by insulated gripping
surfaces (handle) when performing the operation to
prevent a shock to the operator.
WARNING:
The metal surface can become hot during use. Avoid
contact with it to avoid possible burn injury.
NOTICE:
The impact driver is not designed to be used as a drill.
Check the direction of rotation selector for the correct
setting (forward or reverse).
Hold the impact driver with one hand.
Place the bit on the screw head and slowly depress the
switch trigger. Start the bit slowly for more control.
As screw is driven, impacting will begin.
