Klutch 49416, Руководство пользователя, Страница: 13 / 27

Page 13 of 27
13. Move the Connector Seal from the inside to make sure the holes of Drum Upper, Connector Seal,
and Drum Lower align in a line. Insert Bolt (58) with Washer (57) through the holes and rotate
them by hand. Note: Make sure that eight screws are in place, and tighten with a wrench.
Refer to Figure G and Figure H
14. Mount each MixerBlade (2) inside the assembled Drum. The V-shaped bend in the MixerBlade
should point in the direction of the Drum rotation (clockwise). Insert Hex Bolt (1) with Washer (3)
from outside, then Washer (3) and Lock Nut (5). Tighten with a wrench.
Refer to Figure I
15. Insert the handle (64) into support bracket (25) hole from one side.Slide Washer (63) onto the
handle from the other side, insert Pins (67) into theholes, bend the Pins outward so it does not fall
out. (Figure I)
Fig.I
Handle (64)
Support bracket (25)
Fig.H
Mixer blade (2)
Fig.G
Connect Seal (6)
Align the holes
(FigureF)
Bolt (58) &Washer (57)