Klutch 49414, Руководство пользователя

Страница: 11 / 24

Page 11 of 24
See Figure B
5. Place Stand upright.
6. Place Wheel (33) onto Hinge Bracket (34) axle, and slip on the Washer (32) after the wheel.
7. Insert Pins (31) into the Hinge Bracket (34) axle holes, outside each Flat Washer. The pin should
be touching the washer, not the wheel.
8. Bend each side of the Pins outward so they do not fall out.
9. With two people, set the Drum Lower (8) with attached Support Arm assembly into Stand
assembly so that the Shaft (35) is on the wheel side and the Iron Tube (18) is on the Support
Bracket (25) side of the assembly.
10. Insert Hex Bolts (59) with Washer through holes from one side, then Washer and Lock Nut from
the other side, and tighten with a wrench.
See Figure C
11. With the help of another person, attach Connector Seal (6) to the Drum Lower (8), making sure
that the holes in both align. This Connect Seal must be flat on the Drum Lower to ensure a proper
seal.
Fig. B
Pin
Wheel (33)
Iron Tube
(18)
Shaft (35)
Bolt
&Washer
Bolt
&Washer
Fig. C
Connect Seal (6)