KlipXtreme BigBash KWS-920, Руководство пользователя

Страница: 4 / 10

1. Turn the main volume, echo and mic volume controls on the top panel fully counterclockwise.
2. Insert the power cable in the AC jack on the back of the unit, and plug the other end into a standard wall
outlet.
3. Turn the power switch to the on position.
Start by pressing the
ST-BY
button once on the top panel to activate the speaker functions.
Next, enable the
Bluetooth ®
feature on your audio device and set it to discover the wireless speaker.
Remember to place your wireless device and the speaker not more than one meter away from each other.
Select the
Bluetooth ®
feature on the speaker by pressing the
BT
button found on the media panel. A tone
will be heard, while the bt symbol appears on the display with the dot blinking to indicate that the speaker
has entered into the pairing mode.
Once the speaker appears listed under the newly found
Bluetooth ®
devices (KWS-920) of your wireless
device, it will ask if you want to pair with it.
Accept by pressing
Yes
or
Ok
. If you have a lower
Bluetooth
®
version, you may be prompted to enter the
passkey
0000
(4 zeros).
When pairing is successful, the dot next to the
bt
symbol will stop blinking and appear steady on the display.
If after 60 seconds the pairing process fails, please repeat steps 1 through 6 described above.
You can now start streaming audio through the speaker wirelessly from your favorite
Bluetooth
®
-enabled
devices.
Pres and hold the for 3 seconds in order to put the speaker back into pairing mode.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Insert AA batteries into the handheld microphones by carefully unscrewing the base of each one and
aligning the “+” and “-“ terminals of the batteries with the corresponding contacts inside the compartment.
With the Mic. volume 1 and 2 controls turned down, switch on each wireless microphone in turn . The
LED screen on each unit will become illuminated.
Gradually increase the volume and echo controls, testing each microphone output through the speaker. As
you increase the volume, make sure not to stand too close to the speaker to avoid loud feedback.
When not in use, switch the wireless microphones off to conserve battery power.
1.
2.
3.
4.
Note:
Before installing this product, please make sure your device has the built-in
Bluetooth
®
feature available.
Powering on the unit
Pairing the speaker with wireless devices
Using the wireless microphones
IV. Initial setup
V. Advanced operation
Control Description
It replicates the function of the
Standby
button on the top panel
It replicates the function of the same button located on the top panel
It glows every time the remote is used
Cancels the audio coming from the speaker. Press it again to unmute the
speaker
Increases or decreases the treble (high) frequencies at a range between -6dB
to +6dB
It replicates the function of the same button located on the top panel
Press these butons to increase or decrease the output volume of the speaker
It replicates the function of the same button located on the top panel
It replicates the function of the same buttons located on the top panel
Press any of these buttons to select the corresponding input mode
Briefly press this button to reset the speaker to factory default values
Scanning, channel selection, tuning and storage of favorite frequencies
In USB mode, press any key from 0 to 9 on the remote to choose directly the
tracks you want to play
In tuner mode, it allows the manual input of frequencies
1. Power button
2.
LED
3. Indicator light
4. Mute button
5.
TREBLE
6.
BASS
10. Aux, BT and USB
11. Reset
12. Tuner
13.
Numbered keypad
9. /
8.
7.
VOL+/VOL-