User's Manual
K&F SONA 5
KLING & FREITAG GMBH © 2017
Version 3.8
Page 9 of 23
4.
Wall and Ceiling Installation
The following is required for mounting the loudspeaker:
•
T20 Torx key
•
19 mm jaw spanner
•
Mounting accessories for installation on walls or ceilings
To do:
Screw the mounting plate (A) through all
4 mounting holes onto the wall or ceiling.
Choose fasteners that are suitable for the
wall or ceiling material. After installation,
the mounting plate incl. speaker must be
capable of carrying the 6-fold of its own
weight. Take suitable measures to prevent
the screw connection from loosening
itself.
Ensure that the rubber washer (B) is on
the bolt.
Screw the thread reducer (C) hand tight
onto the bolt of the mounting plate.
Make sure the slit of the thread reducer is
facing the mounting plate. After assembly
the M10 bolt has to protrude from the
thread reducer.
As an alternative to the mounting plate, you can also mount the Mounting Arm with other
suitable 10 mm bolts.
Warning
If you screw the Mounting Arm onto another 10 mm bolt that is longer than that of the wall
mount, the rubber safety washer loses its function. In this case, if you were to install the
speaker without an additional safety, you would have to secure the thread of the 10 mm bolt
and the thread of the connecting nut so they do not loosen themselves (i.e. with glue for
securing screws).
Tip
Loosen one or two of the three Torx
key srews only. This way you can avoid
having to tighten an Torx screw that
got covered by the Mounting Arm
while you aligned the speaker.
Loosen this screw(s) just enough so that
you can move the Mounting Arm with
some resistance. This will simplify the
final alignment of the speaker. This
will simplify the final alignment of the
speaker.
