User's Manual
K&F SEQUENZA 10 N/W/B & Flying Frame
KLING & FREITAG GMBH © 2017
Version 6.5
Page 34 of 69
11. Flown Disassembly
1.
Basically, you disassemble the array in the reverse order of assembly.
2.
Replace each transport cover when the speakers are hanging at working level.
3.
Just before the bottom speaker
touches the ground, pull the array
in the direction of the arrow.
This way, you make sure that the
array does not stand on the side of
the bottom speaker, but rather on
the castors.
Warning
Always make sure that the chain
hoist is hanging vertically during
lowering. If you do not do this,
the array could sway suddenly.
If the system is not standing on
the castors, this could lead to
diagonal pull during further
lowering.
4.
Lower SEQUENZA 10 B arrays far enough that all systems are on the wheels, then
prepare the SEQUENZA 10 speakers for transport.
•
Place the used Quick Release Pins back onto their intended stand-by positions on the
speaker and flying frame.
•
Push all joint plates back into the speaker.
•
Dismantle all other used components so that they are not exposed and get damaged
during transport.
For arrays with SEQUENZA 10 N/W and a length exceeding 5 m, proceed as described in
sub-section Disassembly of arrays with SEQUENZA 10 N/W exceeding a Length of 5 m.
For arrays with SEQUENZA 10 N/W and a maximum length of 5 m, proceed as described
in sub-section Disassembly of arrays with SEQUENZA 10 N/W and a maximum Length of
5 m.
Содержание SEQUENZA 10
Страница 2: ......
