OPERATING INSTRUCTIONS
INSERT SOCKET ACCESSORY
The insert socket accessory fits into the
large socket on the angle impact wrench.
• To install the socket, insert the socket and
press firmly on the end of the socket until
the socket clicks in place the socket is
firmly seated in the tool.
• To remove the socket, push the release button on the side
D
of the large socket.
Remove the socket and release the button.
WARNING
: To reduce the risk of serious personal injury, place the forward/reverse
button in the lock-off position or turn tool off and disconnect battery pack before
making any adjustments or removing/installing attachments or accessories. An
accidental start-up can cause injury.
WARNING
: Use only impact-rated accessories. Non impact-rated accessories may
break and cause a hazardous condition. Inspect accessories prior to use to ensure
that it con tains no cracks.
CAUTION
: Ensure fastener and/or system will withstand the level of torque generated
by the tool. Excessive torque may cause breakage and possible personal injury.
1
. Place the accessory on the fastener head. Keep the tool pointed straight at the fastener.
2
. Press switch to start operation. Release switch to stop operation. Always check
torque with a torque wrench, as the fastening torque is affected by many factors
including the following:
•
Voltage
: Low voltage, due to a nearly discharged battery, will reduce fastening
torque.
•
Accessory size
: Failure to use the correct accessory size will cause a reduction in
fastening
torque.
•
Bolt size
: Larger bolt diameters generally require higher fastening torque.
Fastening torque will also vary according to length, grade, and torque coefficient.
•
Bolt condition
: Ensure that all threads are free of rust and other debris to allow
proper fastening torque.
D
www.
.com
1.800.561.8187
