Kleenmaid Slope, Инструкция по использованию и гарантийные обязательства

Страница: 7 / 12

7
Description of the rangehood - Fig. 1
1 Control panel
2 Grease filter
3 Grease filter release handle
4 Halogen lamp
5 Vapour screen
6 Telescopic chimney
7 Air outlet (used for filter version only)
Operation –
Model with button panel
Description of control panel and rangehood operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the rangehood suction is switched
on for 5 minutes prior to cooking and to leave in operation during
cooking and for another 15 minutes approximately after terminating
cooking.
Maintenance
Prior to any maintenance operation ensure that the range
hood is disconnected from the power supply.
C l e a n i n g
The rangehood should be cleaned regularly internally and
externally.
For cleaning use a cloth moistened with denatured alcohol
or neutral liquid detergents. Avoid abrasive detergents.
W a r n i n g :
Failure to carry out the basic standards of the cleaning of the
rangehood and replacement of the filters may cause fire risks.
Therefore we recommend observing these instructions.
Grease filter
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must
be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may
discolour slightly, but this does not affect its filtering capacity.
To remove the grease filter, pull the spring release handle
"f“ - (Fig. 2).
Charcoal filter (filter version only)
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
using hot water and a suitable detergent, or in a dishwasher
at 65°C (if the dishwasher is used, select the full cycle
function and leave dishes out).
Eliminate excess water without damaging the filter, then
remove the mattress located inside the plastic frame and put
it in the oven for 10 minutes at 100° C to dry completely.
Replace the mattress every 3 years or when the cloth is
damaged.
Remove the filter holder frame by turning the knobs "g“ 90°
that affix the chimney to the rangehood (Fig. 3).
Insert the pad "i“ of activated carbon into the frame "h“ and
fit the whole back into its housing "j“.
Replacing lamps - Fig. 4
Firstly check that the lamps are well cooled prior to replacing
them.
Use a small screwdriver as a lever on the borders of the
lamp in order to remove the lightbulb.
Unthread the connector "A".
Slide out the lightbulb to be replaced and replace with a new
12V 20W 30° Ø35 12V GU4 PHILIPS STANDARD LINE code
425409.
Carry out the replacement and mount the new lightbulb by
following instructions in the reverse.
If the lights do not work, make sure that the lamps are
fitted properly into their housings before you call for
technical assistance.
Caution
This appliance is designed to be operated by adults. Children
should not be allowed to tamper with the controls or play with
the appliance.
Do not use the rangehood where the grill is not correctly
fixed! The suctioned air must not be conveyed in the same
channel used for fumes discharged by appliances powered
by other than electricity. The environment must always be
adequately aerated when the rangehood and other
appliances powered by other than electricity are used at the
same time. Flambé cooking with a rangehood is
prohibited. The use of a free flame is damaging to the filters
and may cause fire accidents, therefore free flame cooking
must be avoided. Frying of foods must be kept under close
control in order to avoid overheated oil catching fire. Carry
out fumes discharging in accordance with the regulations in
force by local laws for safety and technical restrictions.
INSTRUCTION ON MOUNTING AND USE
GB
on/off light switch
on/off aspiration switch and minimum power
selection
medium power selection aspiration
s w i t c h
maximum power selection aspiration
s w i t c h