Instruction
Manual
PK
120/30 page
19
_____________________________________________________________________________
4.2 Description of the crimping procedure
A crimping process is characterized by the closing motion of the dies (Pos.-No. 2). The
cable lug or connector will be positioned in the stationary half of the crimping die. The
piston will push the moving part of the die towards the compression point.
The crimping process is complete when the dies (Pos.-No. 2) contact and the maximum
operating pressure of the pump is reached.
Detailed remarks about the assembly of the connecting material can be taken from the
assembly instructions in our catalogue.
5. Remarks with respect to the determined use
The pump must be positioned on an even surface with a max. angle of 15°.
In combination with a 2 m high-pressure hose it is not possible to work in a cable trench.
For this application at least a 3m high-pressure hose is needed.
Instruction
Manual
PK
120/30 page
19
_____________________________________________________________________________
4.2 Description of the crimping procedure
A crimping process is characterized by the closing motion of the dies (Pos.-No. 2). The
cable lug or connector will be positioned in the stationary half of the crimping die. The
piston will push the moving part of the die towards the compression point.
The crimping process is complete when the dies (Pos.-No. 2) contact and the maximum
operating pressure of the pump is reached.
Detailed remarks about the assembly of the connecting material can be taken from the
assembly instructions in our catalogue.
5. Remarks with respect to the determined use
The pump must be positioned on an even surface with a max. angle of 15°.
In combination with a 2 m high-pressure hose it is not possible to work in a cable trench.
For this application at least a 3m high-pressure hose is needed.
