In addition to hardware-related malfunctions, if there are any non-standard operations,
power me off for 30 seconds.
Unstable or
missing
broadcast /
cable TV signal
1. I'm on the
antenna, but I
cannot find
channels, and I
broadcast channels
with image
distortion or audio
interruptions.
1. For stable reception of DVB-T2 (digital) and ATV (analog) signals, use an external
antenna with an amplifier (gain 30 dB and more).
Additional power to the antenna input is already transmitted and cannot be
supplied via my USB ports.
Point your antenna toward the nearest TV tower.
If you are using a room antenna, raise it higher, rotate it around your own axle, and
move it around the room.
Make sure that you have selected an antenna in the settings ->Channel -> channel
setup mode menu.
Configure the channels manually.
For a stable image and sound, the indicators shall be from 50% or higher.
Check the integrity of the cable.
2. I'm cable, but I
don't find
channels, and I
broadcast
channels with
image distortion
or audio
interruptions.
2. If you are using cable TV (DVB-C) or a common house antenna, I recommend
connecting without a splitter. If possible, connect me to another antenna cable.
Make sure that you have selected an antenna in the Settings -> Channel -> Channel
setup mode menu.
Configure the channels manually.
Check the integrity of the cable.
Use a signal amplifier.
Sound is
not played on
external
speakers
1. Connecting
speakers via
Bluetooth
1. Connect Bluetooth speakers via the Settings menu – Remote controls and
accessories
- Add a device.
2. Connect speakers
via HDMI
2. Connect the speakers to me via the HDMI (ARC) Jack.
In the Settings menu -> Sound -> Speakers — select "External audio system". In the
Settings menu –> Device Settings -> Inputs - > HDMI EDID version
- set the value to "EDID 1.4".
In Settings menu -> Device Settings - > Sound -> digital output - select Auto, Skip,
PCM, etc.
3. Connect
speakers via AUX
(3.5 mm
headphone jack)
3. Make sure that the audio cable is inserted all the way into the 3.5 jack.
4. Connecting
speakers via optics
4. Attach the speakers to the OPTICAL connector.
In the Settings menu - > Device Settings - > Sound -> Digital output-> select Auto,
Skip, PCM, etc.
Use the VOL button on the remote control to turn down the sound volume until it is
completely turned off. Use the remote control from the speakers to increase the
sound to the desired level.
WHEN SOMETHING GOES WRONG
EN
kivismart.com
9
