6
IMPORTANT: BEFORE ASSEMBLING, MAKE SURE THE GRINDER IS NOT PLUGGED IN.
1.
Loosen the
Black Grinder Head Locking Knob
until the threads are not exposed
inside the
Motor Housing
opening and insert the
Grinder Head
into the
Motor
Housing
with the
Feed Chute
facing straight up. Turn clockwise until the
slot
on
the top of the
Grinder Head aligns with the Pin
inside the
Motor Housing
. Be
sure the
Head
is seated fully into the
Motor Housing
(Figure 1)
. Tighten the
Grinder Head Locking Knob
to lock the
Grinder Head
into place.
(Figure2)
2.
Insert the
Auger
by aligning the
Auger Spline
with the
Drive Shaft
of the
Grinder
.
Slightly turn the auger clockwise until seats into gear housing.
(Figure 3)
.
3.
Place the
Cutting Knife
onto the square portion of the
Auger Pin.
(Figure 4)
. Note
that the
Cutting Knife
is a
ONE-WAY-FIT
design that ensures that the flat side
of the blade edges will face outward.
4.
Place the
Grinder Plate
onto the
Auger Pin
and align the slotted notch in the
Grinder Plate
with the bottom notch in the
Grinder Head
opening.
NOTE:
The
cutting plate will only fit one way and will protrude approx. 1/8” out of the
grinder head) *NOTE: IT IS RECOMMENDED TO ALWAYS USE THE COARSE (10mm)
PLATE FOR THE FIRST GRIND.
(Figure 5)
.
5.
Attach Front Head Ring Nut and turn the Front Ring Nut clockwise until it is
snug against the Grinder Plate. (
Figure 6)
.
6.
Place the neck of the Meat Tray
into the
Grinder Feed Chute Opening and press
down until secure.
(
Figure7
)
1
1
2
3
4
5
6
7
5
