7
SAUSAGE STUFFING INSTRUCTIONS
IMPORTANT:
While one person can stuff sausage with this Grinder, it is recommended that two people
perform this operation. One person to operate the grinder and push meat into the chute with the
Stomper while the other person manages the output into the sausage casing.
TO BEGIN STUFFING:
1.
Place seasoned ground meat into the
Meat Tray
. Do not overfill the
Tray
, place just enough meat to leave the
Feed Chute
area open.
(Figure 1)
2.
Slide a sausage casing over the
Stuffing Funnel
.
(Figure 2)
3.
Pull 4- 6” (10-15 cm) of casing out at of the end of the
Stuffing
Funnel Tube
and tie a knot in the end of the casing.
(Figure 3)
.
4.
Make sure the
Grinder
is in the “OFF” position. Attach the
Grinder
to
the power supply.
5.
Press Grinder “ON” button ( on models #8 and #12) or turn
Grinder
Switch the to the forward “FWD” position (Models #22, #32), . Carefully
start feeding ground meat into the
Feed Chute
. ONLY USE THE
STOMPER TO PUSH MEAT INTO THE HEAD, DO NOT USE YOUR FINGERS
OR ANY OTHER OBJECT.
6.
Hold the casing in place with one hand while feeding the sausage
mixture through the
Grinder
. As the meat fills the casing, gently lay it
on a clean, dry surface.
(Figure 4)
7.
Do not fill the last 4-6” (10 – 15.24 cm) of casing. After the entire
length of casing has been stuffed, twist the open end to close, then tie
off the ends of the casing tightly to close. Twist into links if desired.
8.
Whenever stuffing sausage, fill the casing slowly to avoid air pockets. If
air pockets do appear in the sausage use a pin to prick the bubbles. The
small holes will seal naturally.
WARNING! NEVER RUN GRINDER DRY WITHOUT MEAT! It can cause damage to the unit, Meat
becomes a lubricant when passing through the grinder, if you run out of meat, turn the grinder off
immediately.
WARNING! Before cleaning, assembling or disassembling the Grinder, make sure the PLUG IS REMOVED FROM THE
OUTLET POWER SOURCE! ALWAYS unplug the Grinder when not in use. After unplugging the unit, turn power switch
ON, then OFF to ensure that all power has been discharged from the grinder.
