21
Oven Door
For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.
To Remove:
1.
Open oven door all the way.
2.
Pinch the hinge latch between two fingers and pull forward.
Repeat on other side of oven door.
3.
Close the oven door as far as it will shut.
4.
Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.
To Replace:
1.
Insert both hanger arms into the door. Be sure that the hinge
notches are engaged in the oven door frame.
2.
Open the oven door.
The door should be able to open all the way.
3.
Move the hinge levers back to the locked position. Check
that the door is free to open and close and is level while
closed. If it is not, repeat the removal and installation
procedures.
A
A. Hinge latch
A
A. Hinge notch
Complete Installation
1.
Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2.
Check that you have all of your tools.
3.
Check that you have all of the range accessories, especially
oven racks. These accessories may be in the range
packaging.
4.
Dispose of/recycle all packaging materials.
5.
Check that the range is level. See the “Level Range” section.
6.
Use a mild solution of liquid household cleaner and warm
water to remove waxy residue caused by shipping material.
Dry thoroughly with a soft cloth. For more information, see
the “Range Care” section of the User Guide.
7.
Read the User Guide.
8.
Turn on surface burners and oven. See the User Guide for
specific instructions on range operation.
NOTE:
Odors and smoke are normal when the oven is used
the first few times.
If Range Does Not Operate, Check the Following:
■
Household fuse is intact and tight, or circuit breaker has not
tripped.
■
Gas pressure regulator shutoff valve is in the open position.
■
Range is plugged into a grounded outlet.
■
Electrical supply is connected.
IMPORTANT:
If the range control displays an “F9” or “F9, E0”
error code, the electrical outlet in the home may be miswired.
Disconnect power and contact a qualified electrician to verify
the electrical supply.
9.
When the range has been on for 5 minutes, check for heat. If
the range is cold, turn off the range and check that the gas
supply line shutoff valve is open.
■
If the gas supply line shutoff valve is closed, open it, and
then repeat the 5-minute test as outlined above.
■
If the gas supply line shutoff valve is open, close it, and
contact a qualified technician.
If You Need Assistance or Service:
Please reference the “Warranty” section of the User Guide to
contact service.
