27
3.
Unscrew the metal cover and unscrew the blue regulator cap.
Keep the washer in place.
A. Metal cover
B. Washer
C. Blue regulator cap
4.
Flip the blue regulator cap over and screw it back into the
metal cover.
A. Propane gas position
B. Natural gas position
5.
Screw the metal cover securely back into place. Do not
overtighten.
To Convert Surface Burners (Propane Gas to
Natural Gas)
1.
If they are installed, remove the burner grates.
2.
Remove the burner caps.
3.
Remove the burner base.
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
Large Burner
A. Burner cap
B. Burner base
C. Gas tube opening
D. Choke (for use with large burner, Propane gas only)
4.
Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
5.
Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number,
marked with 1 or 2 color dots, and have a groove in the hex
area. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement. Remove choke from large burner base.
Natural Gas Orifice Spud Chart
Burner Rating
Size (mm)
ID Number
19,000 BTU (ST)
1.96
196AM
17,000 BTU (ST)
1.84
184AM
18,000 BTU
1.98
198AM
17,000 BTU
1.96
196AM
15,000 BTU
1.75
175AM
9,200 BTU
1.35
135AM
8,000 BTU
1.25
125AM
5,000 BTU
1.00
100AM
1,450 BTU
0.53
053AM
NOTE:
Refer to the model/serial/rating plate located on the
oven frame behind the top right-hand side of the oven door for
proper sizing of spuds for each burner location.
6.
Place Propane gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Propane gas orifice spuds in case of
reinstallation with Propane gas.
7.
Replace the burner base.
8.
Replace burner cap.
9.
Repeat steps 1 to 7 for the remaining burners.
10.
Replace the baking drawer. See the “Remove/Replace
Drawer” section.
