21
If the automatic ice dispenser stops working:
•
Are the ice cubes stuck because the automatic ice dispenser has not been used for some time? Shake
the ice bucket to separate the cubes and increase the holding capacity. It is advisable to throw away the
old ice cubes and make new ice.
•
Has the ice dispenser lever been pressed for too long? Wait about 3 minutes for the dispenser motor to
reset. Large amounts of ice cubes should be drawn directly from the bucket, and not through the
dispenser.
If the ice has an unpleasant smell or taste:
•
Has the ice absorbed bad odours? Is the quality of the water good? It is advisable to make new ice.
Throw away the old ice and make new ice. Keep excess ice in a covered container. Water containing
minerals may require a filter.
•
Is the food properly covered?
•
Is the ice bucket/freezer compartment clean? Follow the instructions for the correct ice dispenser
water supply.
•
Are the pipes correctly connected to the ice dispenser? The first ice cubes coming out of the dispenser
may have an unpleasant taste, therefore it is advisable to discard them and make new ice cubes.
If the dispenser does not dispense ice when the lever is pressed:
•
Change the ice selection from cubes to crushed ice, or vice versa, in order to remove any ice blocks. If
the dispenser still does not dispense ice, wait a couple of minutes and repeat the operation.
If there is condensate in the ice and water dispenser:
• Press the corresponding button to activate the anticondensate
function.
Automatic ice-maker noises (in some models):
Since the appliance is equipped with an automatic ice-maker, you
may hear a humming sound (coming from the water valve), water
trickling and the sound of ice falling into the bucket.
Blown lamp:
1. Always unplug the appliance.
2. Refer to chapter “Maintenance and Cleaning”
IMPORTANT
• If ice is still not dispensed when the lever is pressed, wait a couple of minutes and repeat the
operation.
• If there is condensate in the ice/water dispenser area, press the corresponding switch
(marked with A in the figure) to activate the anticondensate device.
If, on pressing the lever, the dispenser does not dispense, change the selection mode from cubes to
crushed ice, or vice versa, in order to remove any ice blocks.
Troubleshooting guide
5019_715_02010_GB_IFU_SbS.qxp 12-03-2007 9:36 Pagina 21
