18
The water filter is located below the freezer
compartment door.
1. Locate the water filter cartridge cap in the front base
grille below the freezer compartment door. Rotate the
cap counterclockwise to a vertical position and pull the
cap and filter cartridge out through the base grille.
NOTE:
Since there is water in the cartridge, some
spilling may occur.
2. Remove the cartridge cap by sliding it off the end of
the old cartridge. The cap will slide to the left or right.
DO NOT DISCARD THE CAP
.
3. Take the new cartridge out of its packaging and
remove the protective cover from the o-rings.
4. Slide the cartridge cap onto the new cartridge as
shown.
5. With cartridge cap in the vertical position, push the
new filter cartridge into the base grille until it stops.
Rotate the cartridge cap clockwise to a horizontal
position.
6.
RUN WATER THROUGH THE DISPENSER
UNTIL THE WATER RUNS CLEAR
(about 9-14
litres or 6-7 minutes). This will clean the system and
clear air from the lines.
NOTE:
as air is cleared from the system, water may
spurt out of the dispenser.
Ordering replacement filters
To order more water filter cartridges, please contact your
KitchenAid Customer Care Centre.
Changing a water filter cartridge
1
2
3
4
5
5019_715_02010_GB_IFU_SbS.qxp 12-03-2007 9:36 Pagina 18
