Standby
This function turns off the refrigerator and freezer
compartments.
To activate the standby function, press the button
for 3 seconds. To reset the function, carry out the
same procedure until the previously set
temperatures are displayed.
When the appliance is in standby mode, the light
inside the refrigerator compartment is off.
Remember that this operation does not disconnect
the appliance from the power supply.
ALARMS
The display light comes on whenever an alarm
situation occurs.
The alarm symbol is generally associated with an
acoustic signal.
To deactivate it, press the OK button.
The alarm symbol is activated when:
•
the appliance is connected to the power supply
for the first time
•
after a long idle period
•
the freezer compartment temperature is
inadequate
•
the amount of food placed in the freezer
exceeds that indicated on the rating plate
•
one of the doors has been left open for more than
2 minutes
Power failure alarm
It is activated when the appliance is disconnected
from the power supply or in case of a prolonged
power failure that has caused an increase in the
freezer compartment temperature. The maximum
temperature reached during the power failure
flashes on the freezer display.
To deactivate the acoustic signal, press the OK
button
Note
: A decrease in the temperature values on the
display indicates a higher temperature in the
freezer compartment, therefore make sure to
check the quality of the food before putting it back
in the freezer compartment or consuming it.
Door open alarm
The door alarm symbol lights up and the acoustic
signal is activated when one or both doors of the
refrigerator and/or freezer have remained open for
more than 2 minutes.
Note
: Check the door and after closing it press
the OK button to deactivate the acoustic signal.
Operation alarms
This alarm signals a problem in the appliance.
In case of operation alarms, alarm indications will
also be displayed in the refrigerator or freezer
compartment, depending on where the fault
occurred.
Note
: Call the After-sales Service, specifying the
code shown in place of the temperature on the
display.
Press the OK button to deactivate the acoustic
signal.
OPERATION SYMBOLS
Sensor function
Lighting up of the symbols indicates that the
appliance is working to reach the optimum storage
conditions.
The function is automatically activated when:
•
a large amount of food to be chilled and/or
frozen is introduced
•
the refrigerator and/or freezer door is left open
for a long time
•
a prolonged power failure has occurred and the
temperature inside the appliance has increased
to values that cannot guarantee correct storage
of food. The symbol is briefly animated, after
which it remains lit until optimal storage
conditions have been automatically restored.
Water filter
Important:
The filter cartridge must be replaced
only after F1% is shown on the display.
Replace the filter cartridge and press the OK
button until the F99% symbol appears.
The water filter is located under the freezer
compartment door.
This symbol indicates the state of the water filter.
When the product is purchased, and after its
replacement, the symbol corresponding to the
filter displays the percentage of F99%, which
decreases according to use of the product and the
natural depletion of the filter charge.
When a new filter is required, for a subsequent
replacement, the F10% symbol on the display
flashes and an acoustic signal is activated.
Press OK to deactivate it.
Using the appliance
15
5019_715_02010_GB_IFU_SbS.qxp 12-03-2007 9:36 Pagina 15
