www.kitchenaid.com.au | www.kitchenaid.co.nz
Page | 12
Installation
The cook top is designed to be built in to a work surface as shown in the figure.
Before installing the cook top, install the gasket seal
“X”
around the entire perimeter of the hole where it
will be inserted.
The dimensions of the hole are shown in figures 6-7-8-9.
For Filo top (semi flush) models, the perimeter of the hole must be lowered by a depth of 1.5 mm.
The hole does not need to be milled for Semi-filo (semi flush) top models.
The cook top can be installed on different materials such as brickwork, steel, marble, conglomerates,
synthetics, wood and wood covered with plastic laminates, so long as resistant to a temperature of 90 °C.
Adaption to a different type of gas supply
If you are using a different kind of gas from the
one indicated on the serial no. plate and the
orange label on the back of the hob, you must
replace the injectors; in the case of the Wok
burner, adjust the primary air (see Injector
table on page 6). The orange label should be
removed and kept together with the manual.
Use pressure regulators suitable for the gas
pressures indicated on page 6
• In order to replace the injectors, contact
the Customer Care, or a qualified electrician.
• Injectors not supplied as standard should
be requested from the Customer Care Centre.
• Regulate the minimum levels of the taps.
If you experience difficulty in turning the control
knob, contact our Customer Care Centre:
Australia:
New Zealand:
who will
arrange for a replacement after ascertaining that
the tap is damaged.
