www.kitchenaid.com.au | www.kitchenaid.co.nz
Page | 11
• In some cases burner will fail to ignite immediately and will seem to blow’s lightly when do ignite, this
is usually due to the air in the gas pipe which should clear itself within seconds of operation.
If after following instructions given, satisfactory performance cannot be obtained, contact the local gas
authority for advice and assistance.
Electrical Connection
The electrical connections must comply with current local
legislation and be carried out by a qualified, competent person.
• Information on the voltage and power absorbed are shown on
the serial number plate.
•
The appliance must be earthed.
• When installing the appliance, we recommend that this
hob is protected by a 3mm bi-polar switch.
• If damaged, the power cable must be replaced with an
identical type of power cable. We recommend that this
operation be conducted by our After Sales Service. Please
contact our Customer Care Centre.
• Do not use extension cables.
• The manufacturer declines all responsibility for damage to
persons, pets or goods as a result of failure to comply with the
regulations above.
WIRING DIAGRAM
Earth
(yellow/green)
L
N
