8
Call Service
If the Call Service indicator light is flashing, call for service. See
the “Assistance or Service” section for information on calling for
service.
NOTE: To deactivate the audio alarm and indicator light, see
“Master Alarm Reset.”
Top Grille Temperature Display (Pro Line® Models Only)
The top grille temperature display shows the freezer and
refrigerator temperatures. The display will show either Fahrenheit
or Celsius, depending on the selected reading inside the
refrigerator.
During the defrost cycle, the temperature display will show the
temperature set points.
Water Filter Indicator
The water filter indicator, located on the control panel, will help
you know when to change the water filter.
A new water filter should display a reading of 99%. The reading in
the display will decrease as the filter life is used. A replacement
water filter should be ordered when “Order Filter” is displayed. It
is recommended that you replace the filter when “Change Filter”
is displayed or when water flow to your water dispenser and/or
icemaker decreases noticeably. See “Changing the Water Filter”
later in this section.
After changing the water filter, press and hold RESET for
2 seconds until the status display changes to 99%.
Water Filtration System
NOTE: Do not use with water that is microbiologically unsafe
or of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction may
be used on disinfected waters that may contain filterable
cysts.
Replacing the Water Filter
1. Locate the water filter cap in the front base grille. Rotate the
cap counterclockwise to a vertical position and pull the cap
and filter cartridge out through the base grille.
NOTE: There will be water in the filter. Some spilling may
occur.
2. Remove the cap by sliding it off the end of the old water filter.
The cap will slide to the left or right.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
3. Take the new water filter out of its packaging and remove the
protective cover from the o-rings. Discard the protective
cover.
4. Slide the cartridge cap onto the new cartridge. See
illustration in Step 2.
5. With cap in the vertical position, push the new water filter into
the base grille until it stops. Rotate the cap clockwise to a
horizontal position. Discard the first three batches of ice
produced after replacing the filter.
Using the Ice Maker Without a Water Filter
You can operate the ice maker without a water filter. Your ice will
not be filtered.
1. Remove the water filter.
2. Slide the cap off the end of the filter. With the cap in the
vertical position, insert the cap into the base grille until it
stops.
IMPORTANT: Do not discard the cap. It is part of your
refrigerator. Keep the cap to use with the replacement filter.
3. Rotate the cap to a horizontal position. The cap might not be
even with the base grille.
A. Freezer temperature display
B. Refrigerator temperature display
B
A
