Kistler-Morse Microcell, Руководство по установке

Страница: 29 / 44

.
Figure 3-14. Inserting Shielded Interconnect
Cable Through PG13.5 Fitting and Cap.
2. See Figure 4-15 (for a conduited installation) or
Figure 4-16 (for a non-conduited installation).
Route the 3-conductor cable through the
fitting into the junction box farthest from the
signal processor. Connect wires from the
cable to the TB3 terminal in the junction box;
black wire to B terminal, white wire to W
terminal, and red wire to R terminal. Connect
the cable shield wire to the Shield terminal
between TB1 and TB2.
3. Route the cable through conduit/cable tray
to the next junction box. Estimate the
required length of cable to the terminal strip,
allowing a little extra for strain relief. Cut
the excess cable. Connect wires from the
cable to the TB1 terminal in the junction box;
black wire to the B terminal, white wire to the
W terminal, and red wire to the R terminal.
Connect the cable shield wire to the the Shield
terminal between TB1 and TB2.
4. Route another 3-conductor cable through the
fitting into this junction box, and attach wires
to the TB2 terminal; black wire to B terminal,
white wire to W terminal, and red wire to R
terminal. Connect the cable shield wire to the
Shield terminal between TB1 and TB2.
5. Repeat Steps 3 and 4 until all junction boxes
for the vessel are wired together.
6. Route the cable from the last jucntion box
through conduit/cable tray to the signal
processor. Refer to the signal processor
manual for wiring the junction box to the signal
processor. One vessel takes up one channel in
the signal processor. The channel shows the
average value from all the Microcells™ on the
vessel supports.
Note
Ground the cable shield only at the signal
processor.
Figure 4-15. Wiring Junction Boxes Together - Conduited Installation.
25