KisanKraft
®
AGRICULTURAL INTER-CULTIVATOR
KK-IC-750RT
This warranty is null & void, if you fail to register the warranty with
KisanKraft by sending the KisanKraft Copy with dealer’s stamp.
: +91.80. 6835 7800
Page 16 of 36
Ⅳ
Starting(attention: the shift lever must be in the neutral position)
1.
Start diesel engine according to the procedure of instruction.
2.
The diesel engine should run 2 to 3 minutes at the idle speed (1500 to 2000r/m)
with no-load.
3.
Check if the diesel engine runs normally. If not, it should stop working and be
inspected.
Ⅴ
operation(attention: mini tiller must go through running-in before operating.
Please refer to chapter4)
1. Slow gear
1.
Hold the clutch bar with left hand to open the clutch.
2.
pull back the shift lever with right hand, meanwhile, pay attention if it is in the
slow position, then hold the right bar with right hand(attention: do not hold the
backshift bar).
3.
Slowly unlock the clutch bar to close the clutch. In this situation, mini tiller can
run at slow gear.
4.
Speed up properly with right hand, then mini tiller can run at a low speed of
5km/h.
5.
Fast gear
6.
Hold the clutch bar with left hand to open the clutch.
7.
Push the shift lever to the front with right hand, meanwhile, pay attention if it is
in the fast position, then hold the bar with right hand(attention: do not hold the
backshift bar)
8.
Slowly unlock the clutch bar to close the clutch. In this situation, mini tiller can
run at fast gear.
9.
Speed up properly with right hand, then mini tiller can run at a speed of 10km/h.
3. Back gear
•
Hold the clutch bar with left hand to open the clutch.
•
Adjust the shift lever to the neutral position with right hand.
•
Slowly unlock the clutch bar to close the clutch, then mini tiller will step back.(
attention: do not unlock
the backshift bar)
•
If it is unnecessary to step back, you should holdfast clutch bar slowly with left
hand, then unlock the shift bar with right hand.
1.
When shifting in the process of running, you should decelerate (the standard
should be the continuous work of diesel engine), then close the clutch. You should
change the shift until the machine stop working
2.
When changing the direction, you should rotate the bar to left or right.(attention:
do not mis-hold the bar, so as to avoid damaging the wheels when directing)
3.
Stop working
•
Hold the clutch bar with left hand to open the clutch.
•
After adjusting the shift lever to the neutral position, you should unlock the
clutch bar to make the machine stop working.
•
When it necessary to stop working, the procedure should be done according to
the diesel engine instruction.(attention: this work is usually done on the smooth
ground.)
