7
INSTALLATION
INSTALLATION
If You Have a DC Power Supply
Connect the Power Supply
■
Plug the power cable from the shade into the extension cable.
■
Plug the other end of the extension cable into the DC power supply.
■
Plug the DC power supply into a standard outlet.
■
Secure the power supply cable using wire retainers (not supplied). If hiding the cable
behind the shade, make sure it does not impede the operation of the shade.
■
Space the wire retainers approximately 15” apart along the power supply cable,
as shown.
WARNING:
Keep cords and small parts out of the reach of children. They can
wrap cords around their necks and
STRANGLE
.
They can also put small parts in
their mouths and
CHOKE
.
WARNING:
Electric shock and/or a fire hazard may occur if the DC power
supply and cables are not properly installed.
Proceed to “Unpack the Wand and Add to Activation Arm” on page 7.
If You Have a DC Power Supply with Daisy-Chain Connections
The daisy-chain feature allows up to three Soft Touch shades to be powered by a single DC power supply. However, each shade can
operate independently. The daisy-chain feature is only available with the DC power supply option.
■
Route the power cables from each shade through the connector, using an extension cable,if necessary.
■
Plug an extension cable into the connector and the DC power supply. A two-shade configuration is shown below.
■
An additional connector and two additional extension cables are used for three shades.
Unpack the Wand and Add to Activation Arm
■
Remove the wand from the bag.
■
Attach the top of the wand (magnet side) to the activation arm.
Proceed to “Unpack the Wand and Add to Activation Arm” on page 7.
Power Cable
from Shade
Extension
Cable
DC
Power
Supply
15"
Maximum
Wire Retainers
Power
Cable
from the
Shade
Power Cable
from the
Shade
Extension
Cable
DC Power
Supply
Activation
Arm
Magnet
