7
INSTALLATION
INSTALLATION — HANG STRIP
Hang Strip to the Side (HSS) — Outside (OM) Mount Only
Hinges on Both Hang Strips
Step A. Install the Frame
1.
Attach the hang strips.
■
➤
Mark the desired location of the hang strips, centered on the opening.
■
➤
Attach each hanging strip with one screw above the top hinge.
NOTE:
To hold and mount the panel with the hang strip simultaneously, attach the two by placing a rubber band around the
two hinge barrels.
Step B. Mount the panels
1.
Attach the panel(s) and check panel alignment with the hang strip.
■
➤
Adjust the hinges if necessary.
Step C. Racking and Securing
1.
Rack the panels to the desired location and mark the bottom placement of each hang strip.
2.
Attach each hang strip with a screw above the bottom hinge.
■
➤
Close the panels and adjust if necessary.
■
➤
Attach all remaining screws, checking panel alignment after each screw is attached.
3.
Perform any necessary finish work to complete the installation (see Page 24).
Bi-Fold Track Systems
Step A. Assemble the Frame
■
■
See “Assemble the Frame” on page 3. Note that most bi-fold track systems have three-sided frames.
■
■
If build-out is required, mount it to the frame.
■
■
If an aluminum track is attached to the top frame, remove it before proceeding.
Step B. Install the Frame
1.
Position the frame for mounting.
■
➤
Outside (OM) Mount.
Center the frame over the opening. There should be a
1
⁄
4
" reveal on all three sides (or an equal reveal if
a larger or smaller reveal was specified on the original order).
■
➤
Inside (IM) Mount.
Center the frame in the opening. Insert temporary shims under the side frames to hold the top frame
piece against the jamb.
INSTALLATION — BI-FOLD TRACK SYSTEMS
