24
INSTALLATION
INSTALLATION — FINISH WORK
Finish Work
No-Measure Magnets
Most shutters come with magnets attached. If they are not attached, follow the mounting procedure described below:
1.
Mark the frame top and bottom where the panel’s rail and stile meet.
2.
Using the flat head screw provided, mount the strike plate to the rail.
■
➤
Position the strike plate flush with the edge of the shutter rail and tight against the
stile.
■
➤
Attach the strike plate with the screw as shown. Make sure the head of the screw is
flush with or below the surface of the strike plate.
3.
Mount the magnet base to the frame’s light stop.
■
➤
Position the base so that the edge of the magnet is aligned with your pencil
mark, and the magnet “face” is on the hinged side of the mark.
■
➤
Use the pan head screws provided and place the screws in the center of the
slots to allow the magnet to move if adjustment is required.
■
➤
For unframed applications where light stop will not be installed top and
bottom, a magnet spacer will be sent. Attach the spacer to the magnet base
then use the long magnet screws to mount the magnets.
Rail
Strike
Plate
Strike Plate
Screw
Stile
