13
INSTALLATION
INSTALLATION — BYPASS TRACK SYSTEMS
3.
If the tracks arrived attached, use the same holes and re-attach the aluminum tracks to the top frame with the screws supplied.
Be sure the holes line up correctly. If the tracks did not arrive attached:
■
➤
Standard Bypass Systems:
Attach one track against the light stop and the other track flush with the front edge of the top
frame.
■
➤
Open Bypass Systems:
Attach one track against the front light stop and one track against the back light stop.
■
➤
Triple Track Systems:
Attach the front and back tracks against the front and back light stops. Attach the middle track
centered between the front and back tracks.
Step E. Attach Privacy Strips (Triple Track and Open Bypass Only)
1.
Remove the liner from the adhesive on the privacy strips.
2.
Position the privacy strips on the panels as needed for the opening (see illustrations).
3.
Press each privacy strip firmly against the stile. Be sure to apply pressure at several places along the full length of the privacy
strips. Secure each strip with two screws (provided).
Step F. Attach the Shutter Panels
1.
Mount the panels onto the carriers and lock them in place by rotating the lever on the receiver. Continue until all panels are
secure.
2.
Check that floor clearance is acceptable. If not, lower or raise the panel by adjusting both of its carrier bolts the same amount.
Use the wrench provided.
3.
If panels are to be paired, attach inter-panel clips (if not already attached) and snap the panels together.
Front Panel
Front Panel
Middle Panel
Rear Panel
Rear Panel
Privacy Strips
Privacy Strips
Triple Track
(Top View)
Open Bypass
(Top View)
Privacy Strips
Carrier
Receiver
