7
INSTALLATION
OPERATION
To Raise and Lower the Blind
■
Tilt the slats to the open position (flat and parallel to headrail).
■
Pull the single lift cord down and toward the center of the blind.
■
Raise or lower blind to desired position.
■
Move the cord toward the outside of the blind to lock, then release.
Cordless Blinds
To Tilt the Slats
■
Rotate the wand tilter (if ordered) to rotate slats forwards and backwards.
To Raise and Lower the Blind
■
Tilt the slats to the open position (flat and parallel to headrail).
■
Grasp the bottom rail near the center with one hand while balancing the bottom rail with your other hand.
■
Fully press the center button with your thumb and gently lift the bottom rail.
■
Allow the slats to stack evenly by gradually lifting the bottom rail while the center button is fully depressed.
■
Hold the rail still at the desired position while releasing the button.
■
For Inside Mount Blinds:
➤
When raising the blind, pull the bottom rail slightly toward you.
➤
Press the center button and gently raise the bottom rail.
➤
Once the desired height is reached, hold the rail in place while releasing the button.
➤
Place the blind back into the window opening and the blind will stay in that position.
To Lower the Blind
■
Tilt the slats to the open position (flat and parallel to headrail).
■
Prior to lowering the blind, fully press the center button with your thumb and pull the bottom rail down to the desired height
while the button is fully depressed.
■
Once the blind reaches the preferred position, hold it there while releasing the button and the blind will stay in that position.
■
For Inside Mount Blinds:
➤
When lowering the blind to the full-down position, pull the bottom rail down and slightly toward you, approximately 1"
beyond the sill.
➤
Release the button, then lift and place the bottom rail up onto the sill.
Troubleshooting
If your shade is not operating correctly:
■
First review the guide that came with your control device.
■
Refer to the following troubleshooting procedures for specific solutions for your shade.
If questions remain, please contact Kirsch
®
at
844-KIRSCH2 (844-547-7242).
Problem
The blinds are not aligned.
Solution
For all blinds the ladders may become misaligned in transit. After installation tilt the blind opened and closed several
times to allow the ladders and slats to align themselves.
Problem
The bottom rail is not level.
Solution
Cordless blinds feature a skew adjuster also located in the bottom of the headrail.
■
To level the blind, raise the low side of the bottom rail by turning the screw adjustment feature on the headrail
clockwise with a coin or screwdriver while lifting the weight from the bottom rail.
NOTE:
Turn the skew adjustment that is on the same side as the low side of the bottom rail.
