34
35
2)
3)
5 ~9-digit dialing mode: Extension code composed of digits
0, 7 or 8 should be added before the PABX extension
number to dial.
Press
#
key or PTT button to call.
PSTN Call
1) Make sure that
PSTN call
function has been set by PC
software.
2) There are 8 ~ 30-digit dial modes for PSTN call.
3) Number 0 should be added before PSTN number.
4) Press
#
key or PTT button to call.
5) If
DTMF dialing while PSTN call
function has been set
by PC software, and
forbid data keypad
function is not
activated, you can make DTMF call by inputting the number
while holding down PTT button.
NPD Transfer
1) Make sure that
Non-prescribed data transfer
function has
been set by PC software.
2) Press
+1+9+8+3+# to initiate Emergency NP data system-
wide-call.
3) Press
+1+9+8+4+# to initiate Priority NP data system-
wide-call.
Network Operator Service Call
1) If your transceiver requires network service, it needs the
cooperation of the relevant base station.
2) Before calling the dispatch station, you need make sure
that
Network Operator Service Call
function has been
set.
3) Input the number of the dispatch station (see Appendix
MPT1343 Dial Mode table) +
#
/PTT to call the dispatch
station.
Don't Disturb
1) This function allows transceiver to refuse calls from other
transceivers under special circumstances.
2) Make sure that
Don't Disturb
has been set by PC
software.
3) Dial in the sequence of
+4+9+# to refuse all calls.
4) Dial in the sequence of
+4+9+1+# to refuse voice calls.
5) Dial in the sequence of
+4+9+2+# to refuse data calls.
6) When the setting is completed, warning tone sounds (if it
has been set by PC software) and
Complete
or
SUCCESS
appears on the screen.
Cancel Don't
Disturb
1) Dial in the sequence of # +4+9+# to cancel all
Don't
Disturb
.
2) Dial in the sequence of # +4+9+1+# to cancel voice
Don't
Disturb
.
3) Dial in the sequence of # +4+9+2+# to cancel data
Don't
Disturb
.
4) When the setting is completed, warning tone sounds (if it
has been set by PC software) and
Complete
or
SUCCESS
appears on the screen.