35
CAUTION: To avoid losing control of the Buffer when brush is on the floor surface, hold
on to the handle before plugging the power cord into the wall outlet and before
turning the power switch ON. To avoid possible damage to soft tiles or marking
of waxed and finished non-carpeted floors, disengage the Tech Drive power
assist pedal.
Press the Toe-Touch Control Upper Pedal
⑧
to lower the brush
one notch at a time. Lower the brush as far as the Toe-Touch
Control will allow.
With the Buffer running, move the Sentria® system over the floor
as though you were cleaning a carpet, using slow, steady strokes.
NOTE: The belt should not be stretched when stored for an extended
period. Make sure the green arrows line up for storage.
❏
!
FLOOR BUFFER SET-UP (cont)
To engage the drive belt and Buffer Brush, use the handle to turn
the Belt Lifter all the way to the right (clockwise) until the green
arrows line up. Lower the Headlight Hood
.
➤
DO NOT USE Tech Drive® power assist with the Floor Buffer.
Place Tech Drive power assist in Neutral by stepping on the gray
“N” side (“N” for Neutral) of the Tech Drive N/D Pedal
⑪
.
➤
USING THE FLOOR BUFFER
Because the unit moves forward when the Floor Buffer Brush
touches the floor, make sure the Buffer Nozzle is on its highest
setting. Press the Toe-Touch Control Bottom Pedal
⑨
all the way
down to raise the Buffer Nozzle all the way up.
While holding onto the unit’s handle, turn the Sentria® system ON.
➤
8
6
7
Optional Accessories
9
