© ⅯⅯⅩⅢ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 130318002
139
Kirby Morgan
®
37SS
Chapter 8 - Swing Tongue Catch
Unscrew the hex head bolts.
2) Remove the sealed pull pins by pulling them out
of the helmet ring.
3) Return the pins to your authorized dealer for re-
placement.
8.11.2 Replacement of Sealed Pull Pins
1) Insert the pin(s) into the helmet ring on the base
of the helmet. The cam angle must be correct for the
pins to work.
The cam angle must be correct for the pins to work properly.
2) The screws have a factory applied locking com-
pound on the threads; no thread locker is required.
3) Insert the screws into the helmet ring and tighten
to 5 inch lbs of torque.
The screws that secure the sealed pulled pins must be
properly installed and torqued.
8.12 Swing Tongue Catch
The swing tongue catch assembly helps to provide
alignment for the front of the neck ring assembly, as
well as making it easier to remove the helmet. The
swing tongue catch should rarely need attention or
service, unless damaged accidentally.
