© ⅯⅯⅩⅢ Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 130318002
105
Kirby Morgan
®
37SS
Chapter 7 - Reassembly of the SuperFlow® 350 Demand Regulator
Inspect the whisker valve plastic bodies for damage
and contamination. Install new valves ensuring they
are installed onto the correct side of the plastic body.
17) Install the whisker valve assemblies into the
Quad-Valve main exhaust body. Refer to the notation
or marks made when the parts were disassembled.
B
WARNING
The exhaust valve inserts must be
installed in the correct orientation in
exhaust main body. If the inserts are
installed backwards, the diver will be
unable to exhale. This could lead to
suffocation and death.
18) Install the left and right whiskers then inspect
and install the clamps.
Place whisker clamps around the grooves on each of
the two whiskers. Before doing the final tightening
of the clamps, make sure the parting line on the bot
-
tom of the wings is
5/16
" behind the parting line on
the main body.
Properly re-align the port and starboard wings to the
main body.
19) Pre install a tie wrap as shown onto the whisker
main body. This will make installation much easier
and ensure a good seal.
Pre-install the tie wrap.
20) Insert the regulator into the pod by and align
stretching the main exhaust body onto the quad ex
-
haust extension on the pod.
The exhaust valve inserts are recessed on one side to accept the exhaust valves so they sit flush in the inserts. The exhaust valves
must be installed properly in the inserts or they will not seal or perform properly.
Correct
WRONG
