Kiramek Vision 1014C, Инструкция по эксплуатации

Страница: 29 / 40

26
PROGRAM FEATURES EXPL AINED
When set to
ON
, vehicle lights will illuminate for safety while the Ignition
is turned on by a remote start system.
(Only works if optional light flash is
installed, and only if Remote Start Compatibility Mode is also turned ON .)
When set to
IG Protect Mode
, the system will trigger the siren when the
Ignition goes on while armed, as described on page 23.
When set to
Remote Start Compatibility Mode (RSCM) , the system will by-
pass the Sensor and Ignition triggers and IIP will become active when IG
goes on while armed, as described on page 23.
3 IG Protect Mode / Remote Start Compatibility Mode
4 Vehicle Lights ON During Remote Start
This feature automatically arms the system when you do the following:
(1) Turn IG on, (2) Turn IG off, (3) Open and Close any door. Upon seeing
these events, the system will arm 20 seconds after the last door is closed.
The doors will NOT be locked (so you won’t be locked out if you leave your
keys in the car by accident), but the system will be armed.
8
Auto Arm
After Arming, there is a default 3 sec. delay before the system will accept
alarm triggers (e.g., door, ignition, sensor). This delay is sufficient to let
the vehicle settle after you exit and close the door so the shock sensor will
not be triggered by residual vibration. You can change this delay to
15 min.
for compatibility with vehicles that have long door lock pulses or engine
cooling fans. When set to “15 min.”, The Ignition and Door input triggers
will continue to activate 3 seconds after arming, but the Sensor input will
not activate until 15 minutes after arming.
9 Exit Delay Time Selection
OPERATION