Kiramek Vision 1014C, Инструкция по эксплуатации

Страница: 11 / 40

8
MAIN HARNESS
This wire is the main (–) ground input to the 1014. Be sure to connect this
wire securely to a good ground source.
Most security system installation
problems result from a bad ground connection!
Find a piece of bare metal on the vehicle and use some steel wool to clean it
off before you make your connection. Determine the length of wire needed,
and cut the black wire shorter if necessary. Crimp on the included ring
connector. Screw down your connection tightly.
H1
H1-BLK (–) System GROUND
This wire is the main (+) 12v power input to the 1014. Be sure to connect
this wire securely to a constant 12v source, but connect this wire last so the
siren doesn’t go off.
If you cannot find a constant 12-volt source under the dash, you may need
to run a wire directly to the positive battery terminal in the engine compar-
ment. If you need to extend this 12v power wire, use wire thicker than the
RED wire. Do not bypass the fuse on the RED wire. If you blow the fuse,
replace with a 15A blade type.
H1-RED (+) System POWER
This cream-colored 4-pin connector is to be attached to the included 318-
052 shock sensor, as shown in the diagram on page 7. Optional sensors
(such as VISION RSA-series field sensors or the 318-022 digital tilt sensor)
can be easily added to this line with the purchase of an optional 318-035
Sensor Splitter.
H1-4 pin Shock Sensor Connector
This white 3-pin connector can be attached to the included 318-04 ultrason-
ic sensor, as shown in the diagram on page 7. Be sure to keep the control
unit of the Ultrasonic sensor more than 30cm (1ft) away from the body of
the 318-052 shock sensor to avoid interference and possible false alarms.
H1-3 pin Ultrasonic Sensor Connector
INSTALLATION