Kipp & Zonen Brewer Mk III, Руководство оператора

Страница: 125 / 136

MKIII OPERATOR'S MANUAL 122
PMT.WINDOW.TIME float seconds Immediate
seconds in a window. Should be an integral
multiple of PMT resolution time.
RESET.TIME.OUT
unsigned integer
seconds
on reset
the length of time allowed for initialization of
all motors. This should be larger than the
largest value of MOTOR.TIME.OUT.
RH.ORIGIN float volt at 0 RH immediate
Humidity sensor calibration provided by
manufacturer
RH.SLOPE Float volt/% immediate
Humidity sensor calibration provided by
manufacturer
SUPPLY.CONVERSION
[<powerSupply>]
float Immediate
Number of volts at the output of the supply to
read one volt via the A/D
SUPPLY.DELTA[
<powerSupply>]
float volts on reset
Permitted (max-nominal and nominal-min)
voltage in watermark recording
SUPPLY.NOMINAL [
<powerSupply>]
float volts on reset Center voltage in watermark recording
TEMP.DELTA [ <thermalPoint>] float degrees on reset
Permitted (max-nominal and nominal-min)
temperature excursion in watermark
recording
TEMP.NOMINAL [
<thermalPoint>]
float degrees on reset Center temperature in watermark recording
TEMP.ORIGIN [<thermalPoint>] float degrees Immediate
number of degrees Celsius offset for 0 volts
at the A/D
TEMP.SLOPE [<thermalPoint>] Float degrees/volt immediate
number of degrees Celsius per volt at the A/D
(linear thermistors are used here)
TRACKER.DEBOUNCE.TIME Float seconds immediate
debounce time for the tracker control
switches
USE.B3.FOR.LAMPS Boolean immediate
Sets response to command: B,3. If set to
YES, lamps are turned on else the command
is ignored.
VERSION.ELEC unsigned byte immediate Records the electronics version
VOLTS.PER.BIT Float volts immediate
Resolution of A/D converter in volts per A/D
unit (bit)
Possible <index>es
<index> Meaning possibilities/format
<address> location within the space ANSI C integer format
1
<analogPt> which A/D mux input integer 0 to 23
<digitalPt> which digital input integer 0 to 15
<lamp> which Brewer internal lamp 0 to 1 or identifier - One of: HG, STD
<motorId> identifies a motor see section on I command
<powerSupply> identifies a power supply 0 to 6 or identifier One of:
HV, +12V, +5V, -12V, +24V, +5VSEC (secondary
supply), -5VSEC
<thermalPoint> identifies a thermal sensor 0 to 5 or identifier One of:
PMT (photomultiplier), FAN (internal temperature),
BASE, BELOW.SPECTRO,
WINDOW.AREA, EXTERNAL (external temperature)
<trackerSwitch> identifies a tracker switch
digital input 0 to 4 or identifier One of:
CW, CCW, UP, DOWN, COARSE
Examples
?MOTOR.MAX.ACC[IRIS]
reports the current maximum acceleration for the iris motor.
!PMT.HV.TOLERANCE 50
sets the value of the high voltage tolerance to 50 millivolts.
1
The first character must be a digit. The number interpreted as decimal unless the first digit is a 0 in which
case the second character is tested. If it is 'x' or 'X' the remaining digits are interpreted as a hexadecimal
number. If the second character is a digit the number is interpreted as octal.