Kipor IG6000, Руководство по обслуживанию

Страница: 15 / 38

11
2.8.4 Engine oil level is low, but engine does not stop.
Drain out all engine oil, disconnect the
low oil alarm wire and check if the outlet
terminal is connected to ground
→not
conductive
Replace the oil level alarm switch
↓conductive
Connect the alarm wire, loosen ignition
module receptacle and check if the
orange wire is connected with the ground
→not
conductive
Repair wiring harness
↓conductive
Replace ignition module
2.8.5 Engine speed does not increase or is unstable
Check choke for proper operation
↓ OK →abnormal Adjust/repair choke mechanism
Check the air cleaner
→clogged Clean or replace air cleaner
↓not clogged
Check the valve clearance
→abnormal Adjust the valve clearance
↓normal
Remove the spark plug and check the
electrodes for carbon and spark plug gap
→abnormal
Clean the spark plug and adjust the spark
plug gap or replace new spark plug
↓normal
Check for blockage of the main jet
→clogged
Disassemble and clean or replace
carburetor
↓not clogged
Check the air intake gasket and the
sealing of heat-insulation block of
carburetor
→abnormal
Tighten the nuts securely, replace the
gasket or heat-insulation block
↓normal
Perform the cylinder compression check
→abnormal
1. Check the valve clearance
2. Check combustion chamber for excess
carbon
3. Check the piston, piston ring and
cylinder for wear and damage.
↓normal
Perform the throttle control system
troubleshooting