Kinze 3600, Руководство оператора

Страница: 177 / 382

MAINTENANCE
9-7 Rev. 3/05
BRUSH-TYPE SEED METER TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Low count. Meter RPM too high. Reduce planting speed.
Misalignment between drive See “Seed Meter Drive Adjustment”.
clutch and meter.
Seed sensor not picking up
Clean seed tube.
all seeds dropped. Switch meter to different row. If problem
stays with same row, replace sensor.
Lack of lubrication causing Use graphite or talc as recommended.
seeds not to release from
disc properly.
Seed size too large
Switch to smaller seed or appropriate
for seed disc being used. seed disc. See “Brush-Type Seed
Meter” for proper seed disc for size of
seed being used.
Seed treatment buildup Reduce amount of treatment used
in meter. and/or thoroughly mix treatment with
seed. Add talc.
Low count at low RPM and Foreign material lodged in Remove seed disc and remove
higher count at higher RPM. upper brush. foreign material from between brush
retainer and bristles. Clean thoroughly.
Worn upper brush. Replace. See “Maintenance”.
Low count at higher RPM Seed disc worn in the Replace disc. See “Maintenance”.
and normal count at low RPM. agitation groove area.
High count. Seed size too small for seed Switch to larger seed or appropriate
disc. seed disc.
Incorrect seed rate Reset transmission. Refer to proper rate
transmission setting. chart in “Machine Operation” section of
manual.
Upper brush too wide (fanned Replace upper brush.
out) for small seed size.
High count. (Milo/Grain Sorghum) Incorrect brush retainer Make sure GD8237 brush retainer
being used. is installed to keep upper brush
from fanning out.
Upper brush laid back. Seed treatment buildup Remove brush. Wash with soap and
on brush. water. Dry thoroughly before
reinstalling. See “Maintenance”.
Buildup of foreign material Remove brush retainer and brush. Clean
at base of brush. thoroughly. Reinstall.