Kingsman MDV31, Руководство по установке

Страница: 39 / 61

Gas Conversion –Part A – MDV31 / MDV39
1. Remove ember plates right and left of burner, ember plates are held in place by 2 screws each.
2. Loosen screws from burner retainer tabs and slide burner to the left to remove from orifice.
3. Remove main orifice using a 1/2” wrench and replace with new conversion orifice.
4. Install new pilot orifice and Hi/Lo valve regulator by following instructions supplied with conversion kit (also See Parts B & C).
5. Adjust the primary air setting to the correct setting as specified in the manual or label plate. To adjust air setting, loosen screw on
the side of air mixing tube and rotate to the correct opening using a drill bit or tape measure. Retighten screw.
6. Reinstall ember plates and burner by reversing steps 1 & 2.
Gas Conversion –Part A – MQRB3632
1. Remove four [4] screws holding down the false bottom. Remove the four [4] screws holding down the burner tube assembly.
2. Slide the burner tube towards the left to remove from orifice.
3. Remove main orifice using a 1/2” wrench and replace with new conversion orifice.
4. Install new pilot orifice and Hi/Lo valve regulator by following instructions supplied with conversion kit.
5. Adjust the primary air setting to the correct setting as specified in the manual or label plate. To adjust air setting, loosen screw on
the side of air mixing tube and rotate to the correct opening using a drill bit or tape measure. Retighten screw.
6. Reinstall false bottom and burner by reversing steps 1 & 2. Pilot Shield must be in place over pilot assembly.
Caution:
The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding with the conversion .
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer’s
instruction s and all applicable codes and requirements of the authority having jurisdiction. If the information in these
instructions is not followed exactly a fire, explosion or production of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified service agency is responsible for the proper installation of this kit.
The installation is not proper and complete until the operation of the converted appliance is checked as specified in the
manufacturer’s instructions supplied with kit.
Air Shutter
(Adjustment)
Pilot Shield
False Bottom
Main Orifice
Pilot Assembly
Main Orifice
Air Shutter
(Adjustment)
Ember Plates
Burner Hold Down
Pilot Assembly
Burner Tube
Grate Bar
39