How to Install the Finishing Surround
Figure 13 - Finishing Surround installation guide.
1.
Make note of where the mount locations are. There should be four [4] places as shown in the
illustration on the right.
2.
Slide the Surround onto the unit. Rest the upper ledge of the Surround on top of the unit but
below the Cabinet Shield. The Side Shields of the Surround should slide along the INSIDE
face of the unit.
3.
Using the screws provided, loosely fasten the Surround onto the unit at the four [4] mounting
locations. Adjust the depth of the Surround appropriately, and then tighten the finished.
NOTE: This Surround is capable of extending 5/8” away from the front of the unit. Hence, a
wider range of facing materials can be accommodated without relocating the unit.
4.
To remove the Front Face Surround simply reverse these steps.
This unit is designed to extend its Front Surround 5/8” [15.9mm] outwards to accommodate a larg-
er range of Facing Material without the need for reframing. Therefore, the maximum thickness for
Facing Material is 1-1/8” [28.6mm].
To extend the Front Surround forward:
1.
Loosen the four [4] mounting screws for the Front Surround,
2.
Pull the Surround forward to the desired distance,
3.
And then secure the Surround by tighten the four [4] mounting screws.
The location of the mounting screws is shown in Figure 13.
Thick Facing Materials
16
Содержание Marquis Serenity MQZDV1917
Страница 10: ...General Framing Installations Figure 5 General framing installation 10...
Страница 31: ...Gas Conversion for Modulator PART C WARNING WARNING 31...
Страница 34: ...Configuration 1 Basic manual HI LO and manual ON OFF capabilities 34...
Страница 35: ...Receiver Module 584 523 521 221 1001 P221SI Receiver Module 584 523 521 221 1001 P221SI 35...
