Kingsman IDV26LP, Руководство по установке

Страница: 39 / 72

IDV26 Burner Installation/Removal
Burner Pan Removal
Step 1: Disconnect pilot lines and gas supply line from valve
on the side of the unit. NOTE: Care should be taken to
ensure that the gas and pilot lines are not damaged
during handling. These lines are fragile.
Step 2: Locate and remove the twelve [12] screws around
the outside of the burner pan. This will remove the entire
burner assembly.
To reinstall the burner assembly ensure the surfaces are
cleaned, and old sealant material removed. Use high temp
Millpac to seal and secure with the twelve [12] screws.
Pilot Removal
Disconnect pilot lines from valve as shown above. Remove
fan access panel (Not necessary to remove fan) and use this
space to draw pilot out from unit.
Installation is the reverse of these steps. Reseal pilot
connections to burner pan with orange silicone.
Valve Removal
Disconnect pilot lines and gas supply line from valve on
the side of the unit.
NOTE: Care should be taken to
ensure that the gas and pilot lines are not damaged
during handling. These lines are fragile.
Remove [2] 3/8” nuts holding valve onto Component Plate.
Unhook valve from Component Plate.
CAUTION
Before servicing the burner system ensure that the gas supply is turned OFF and disconnect all electrical connections to
the appliance. Allow the appliance to cool to room temperature. Note that the pilot assembly may be hot in an intermittent
or standing-pilot system—even if the main burner was never on. Exercise caution when working within the area. ALL
WORK SHOULD BE PERFORMED BY A QUALIFIED AND CERTIFIED TECHNICIAN.
Fan Access Panel Removed.
39