25
S
S
S
S
e
e
e
e
c
c
c
c
tt
tt
ii
ii
o
o
o
o
n
n
n
n
B
B
B
B
II
II
n
n
n
n
s
s
s
s
tt
tt
a
a
a
a
ll
ll
ll
ll
a
a
a
a
tt
tt
ii
ii
o
o
o
o
n
n
n
n
II
II
n
n
n
n
s
s
s
s
tt
tt
rr
rr
u
u
u
u
c
c
c
c
tt
tt
ii
ii
o
o
o
o
n
n
n
n
s
s
s
s
GAS CONVERSION KIT FOR TOP
CONVERTIBLE PILOT
SERIES 019065X
SIT Group
Instructions for converting SIT 190 series pilot burner injection from NG to LPG and from NG to LPG Only.
This information should be considered as supplemental to the Appliance Manufacturer’s Instructions.
WARNING!
The installation of this conversion kit must only be undertaken by a qualified
and certified gas appliance installer.
1
Shut off the gas supply to the appliance.
2
Allow the pilot burner to cool to room temperature.
WARNING: Touching a hot pilot burner can result in injury.
3
The pilot hood is held in place by spring pressure.
Remove the hood by pulling it directly up from the pilot bracket (1).
4
Insert a 5/32” or 4mm Allen wrench into the hexagonal key-way of the
injector (2), and rotate it counter clockwise until it is free of the injector
journal (3).
5
Verify that the new injector is proper for the application. The injector size
is stamped on the side of the injector near the top. LPG injectors have a
groove machined around their circumference near the top, while NG
injectors do not have a groove (5).
Refer to the Appliance Manufacturers instruction sheet for the proper
injector size.
6
Insert the Allen wrench into the end of the injector. Then, insert into
injector journal, and rotate the injector clockwise until a torque of 9 in-lbs.
is achieved.
7
Replace the pilot hood by aligning the tab on the base of the hood with the
slot in the side of the pilot journal, and push the hood down, directly onto
the pilot bracket (4). The hood must sit squarely on the bracket for proper
operation. Check to insure that the hood is properly seated onto the pilot
bracket.
8
Proceed to Section A, Step 5.
WARNING!
This conversion kit must only be applied as part of a conversion kit supplied by the
appliance Manufacturer for the specific appliance, and type of gas being converted.
INSTALLER NOTICE. These instructions must be left with appliance.
