24
SECTION A
Note: Before proceeding with step 1, check position of air
adjustment plate. This position will be important for re-
assembly.
Step 1:
Remove air adjustment plate and false bottom plate
before by removing 3 screws.
Step 2:
Loosen 2 screws holding the burner in place.
Step 3:
Slide burner to the left to expose the burner orifice.
Step 5:
Remove main burner orifice using a 1/2” wrench
and replace with new conversion orifice.
Step 6:
Adjust the primary air setting to the correct
setting as specified in the manual or label plate.
To adjust the air setting, loosen the screw on the
side of the tube and rotate to the correct opening
using a drill bit or tape measure. Retighten
screw.
Reinstall burner at this time reversing STEPS 3, 2
and 1.
Step 7:
Follow instructions supplied with the conversion
HI LOW to convert the valve from one type of
fuel to the other.
Step 8:
Check for gas leaks around the pilot burner tube
and face of valve.
Step 9:
Attach conversion label to label plate on bottom
of unit, writing information as needed.
CONVERSION KIT INSTRUCTIONS
Step 4: Proceed to next page (Page 24), Section B.
PLEASE CONFIRM THAT STEP 4 IS UNDERSTOOD
BEFORE PROCEEDING WITH CONVERSION.
“WARNING”
This conversion kit shall be installed by a qualified
service agency in accordance with the manufacturer’s
instructions and all applicable codes and requirements
of the authority having jurisdiction. If the information
in these instructions is not followed exactly, a fire,
explosion or production of carbon monoxide may
result causing property damage, personal injury or loss
of life. The qualified service agency is responsible for
the proper installation of this kit. The installation is not
proper and complete until the operation of the
converted appliance is checked as specified in the
manufacturer’s instructions supplied with the kit”
