AsseMbly
24. Locate the drum (A) Fig.15 and install the 4 casters (B) under the drum by
simply screwing them into the base. Use a wrench to tighten each caster.
25. Install the drum handle (D) Fig.15 on the drum using 2 pan head screws,
washers and acorn nuts.
26. Place the large drum bag (C) Fig.15 inside the drum and fold the edges as
shown.
27. Install drum pressure hose (A) Fig.16 to the fitting on the drum. Slide hose
over fitting and secure hose with hose clamp (B).
28. Connect the other end of the drum pressure hose (A) Fig.17 to the fitting
on the intake housing. Slide hose over fitting and secure hose with hose
clamp (B). Slide drum under the drum lid.
29. Complete the installation of the vacuum pressure system. The drum
pressure hose (A) Fig.18 comes with an adaptor with a clear hose (B)
attached, install the end of the clear hose to the rear of the pressure
gauge (C). Slide clear hose over pressure gauge fitting and secure hose
with hose clamp (D).
FIgure 15
FIgure 16
FIgure 17
FIgure 18