ASSEMbLY & SETUP
INSTALLING THE COOLANT PUMP SYSTEM continued...
5. Fit the drain hose gasket (A) Fig.8 onto the drain hose fitting as shown.
6. Install the drain hose fitting (B) onto the recovery tray at the back of the
machine with two cap screws and washers (C) using a 6mm hex. key.
7. The end of the drain hose(A) Fig.9 should hang into the recovery tank filter (B)
as shown. If necessary, trim the hose to the appropriate length with scissors.
INSTALLING THE DOWNFEED HANDLE
1. Remove the threaded bolt from the head using a wrench. Install the down feed
handle (A) Fig.10 onto the machine head by threading it into the threaded bolt
opening (B). Once feed handle is installed, position it in the desired position,
then tighten the two hex. nuts (C) using a wrench.
2. Rotate the handle (A) Fig.11 to an appropriate position with the trigger (B)
pointing upwards. Secure the handle by tightening the hex. nut (C).
FIGURE 8
FIGURE 9
FIGURE 10
FIGURE 11
