King gates OVO550, Инструкции и предупреждения по установке и использованию

Страница: 8 / 22

7
EN
21
N
O
09. Then secure the leaf connecting bracket [N] with rivets or screws
( fig. 21 ). Use screws or rivets suited to the leaf material, and ensure
that they are able to withstand the maximum force required for leaf
opening and closing.
10. Loosen the screws of the two mechanical stops, then move the
front mechanical stop [P] in front of the carriage ( fig. 22 ).
22
Q
P
11. Push the carriage in the closing direction and, on reaching the
position, tighten the screw [Q] fully down.
12. Manually open the door to the required opening position, move
the rear mechanical stop [R] next to the carriage ( fig. 23 ) and tighten
the screw [Q] fully down. Important! - Make sure the release cord
can be pulled below a height of 1.8 m.
23
Q
R
3.3 - Installation of other devices
If other devices are needed, install them following the directions pro-
vided in the corresponding instructions. Check the devices which
can be connected to OVO in
fig. 1 and in section 3.5 ("Description of
electrical connections").
3.4 - Electrical connections
01. Open the cover by loosening the screw ( fig. 24 ) and pushing the
button ( fig. 25 ).
24
25
02.
Remove the small disc [S] with a screwdriver (
fig. 26
).
26
S
03.
Feed the cables through the hole [S] (
fig. 27
).
27
S
04. Refer to fig. 28 and the connection descriptions in table 5 when
making the connections:
- if using photocells, remove the wire clip between terminals 3 and 7
and follow the connection diagram in
fig. 28 .
- if using the flashing light aerial, remove the wire clip (connected to
terminal 2 as standard) and connect the RG58 shielded cable.