Page 12
DUAL LNB
(Fig. 12)
1. Connect the 35’ coax cable from the dome unit to the tuner port labeled “ANT.”
2. Connect the 3’ coax from the tuner port labeled “REC” to the de-stacker port labeled
“INPUT.”
3. Connect the 7’ controller cable from the controller to the tuner port labeled “IDD.”
4. Connect the port on the de-stacker labeled “IRD Output 1” to the “SAT IN” port on the first
satellite receiver. Connect the port on the de-stacker labeled “IRD Output 2” to the “SAT
IN” port on the second receiver.
5. Connect the power supply cable to the tuner port labeled “PWR”.
6. Plug the power supply into a 110 VAC source.
Note: The controller should turn on for 3 seconds and then turn off. If the controller
stays on, press the ENTER and “-” button simultaneously for 3 seconds to turn
unit off.
ELECTRICAL HAZARD WARNING!
The coaxial cable that connects the dome unit to the tuner
carries a 30 volt electrical current. Exercise extreme
caution when handling this cable. Do not cut, break, or
splice this line. Do not insert or connect any devices such
as splitters or any other device for any reason. This line is
not compatible with any other equipment. Damage will
occur to any device other than the dome unit if connected
to the antenna port on the tuner.
