ELECTRICAL HAZARD WARNING!
The coaxial cable that connects the dome unit to the tuner
carries a 30 volt electrical current. Exercise extreme
caution when handling this cable. Do not cut, break, or
splice this line. Do not insert or connect any devices such
as splitters or any other device for any reason. This line is
not compatible with any other equipment. Damage will
occur to any device other than the dome unit if connected
to the antenna port on the tuner.
Page 10
INTERNAL WIRING:
Determine the location of the internal components using the following criteria:
a) The Controller, Tuner, Power Supply and De-stacker (9762 only) should be in the
same general vicinity of the satellite receiver, and accessible for operation and
maintenance purposes.
b) The Tuner should not be stacked directly on top of other electronics.
c) The Controller should be conveniently located for the end user.
d) All components should be secured so they do not shift or bounce around during
vehicle motion.
SINGLE LNB
(Fig. 11)
(For dual LNB hook-up see Pages 12-13)
1. Connect the 35’ coax cable from the dome unit to the tuner port labeled “ANT.”
2. Connect the 7’ coax from tuner port labeled “REC” to the satellite receiver port labeled
“SATELLITE IN.”
3. Connect the 7’ controller cable from the controller to the tuner port labeled “IDD.”
4. Connect the power supply cable to the tuner port labeled “PWR”.
5. Plug the power supply into a 110 VAC source.
Note: The controller should turn on for 3 seconds and then turn off. If the controller
stays on, press the ENTER and “-” button simultaneously for 3 seconds to turn
unit off.
