Kinetico ERGO RO BLUE, Инструкция по эксплуатации

Страница: 8 / 36

U
M
8
7. TROUBLESHOOTING
SYMPTOM CAUSE SOLUTION
1. Leak outside the system
4. Excessive production
9. System turns constantly on and
off
7. Rejection does not stop.
5. Unpleasant taste and odour.
8. The equipment does not
start
6. Water has a white colour.
2. No production.
3. Low production
Multiple causes
Multiple causes
Multiple causes
Multiple causes
Multiple causes
There is no water supply
There is no power supply *
Air bubbles inside the system.
These micro-bubbles will disap-
pear after a few seconds
There is no water supply
Inlet valve is partially closed
Tank valve is closed
There is no power supply
Call the Technical Service
Call the Technical Service
Call the Technical Service
Call the Technical Service
Call the Technical Service
Check the state of the main inlet
valve of the house and the appli-
ance
Check the general power supply.
If the problem persists, please call
the Technical Service.
This is not a problem. This appear-
ance of the water will slowly disap-
pear as the air inside the system is
removed.
Wait until water supply is re-estab-
lished
Open it
Open it. If the problem persists,
please call the Technical Service
Check the power supply of the
house. If the problem persists,
please call the Technical Service.
11. The equipment supplies a low
water volume
The pressure tank has lost pressure Check it.
Pressurize the air balloon with 0.5
bar when the tank is empty
10. The equipment is always reject-
ing water to the drain
Inlet electrovalve or shut-off valve
are broken down *
Production check-valve is dam-
aged
Check and replace
Check and replace