Kinesis RISE 2020, Руководство пользователя

Страница: 5 / 20

When you have aligned your stem so that it is perfectly straight, you need to torque the
stem bolts to the manufacture specifi cation of 6Nm ( Image 3 ).
STEP 2. PEDALS
To adjust the bars, loosen the two pinch bolts on the side of the stem with a 4mm hex
key. Turn the handlebars 90° so that the stem is pointing directly forward, see pic 2.
The RISE is not supplied with pedals. When fi tting your own pedals ensure that you
use grease on the axles and that the pedals are on the correct side. There should be an
indicator on the axle to distinguish between left and right. Tighten up the pedals to 30 –
34Nm torque with the appropriate tool for your pedals.
STEP 3. SADDLE HEIGHT
Correct saddle adjustment is an important factor in getting the most performance and
comfort from your bicycle.
To check for correct saddle height please follow these steps. You may fi nd it easier to
support yourself against a wall or table on one side. Firstly ensure the X-Fusion Manic
Seat Post is in the extended position.
• sit on the saddle
• place one heel on a pedal
• rotate the crank until the pedal with your heel on it is in the down position and the
crank arm is parallel to the seat tube.
If your leg is bent at the knee with your heel on the pedal, the saddle is too low. If your
hips must rock for the heel to reach the pedal, the saddle is too high.
BEFORE CONTINUIING, PLEASE NOTE: The RISE bike is fi tted with an X-Fusion
Manic ‘dropper style’ seat post. At the bottom of the seat post, where it is inside
the frame, it has an attached hidden cable which feeds through the internal tubes
of the frame and exits the frame at the head tube where it is then connected to
the remote shifter on the handlebar. Any adjustment of the seat post height must
Image 3.